Menu
No products in the cart.
The MMP-300 is our 300 AAC Blackout offering. We built our MMP-300 around the original intent for the 300 AAC Blackout cartridge. This short package is ideal for use with supersonic loadings, as well as subsonic suppressed loadings. These pistols are built to be the functional tool that the end user needs to meet and overcome any challenge.
At the heart of our pistols, we use our M16 cut nitride bolt carrier group, matched with a fully nitrided Ballistic Advantage 8” carbine-length barrel. Our pistol-length gas system provides an extremely soft and controllable recoil impulse. We then paired these components with our tight fitting receivers, and ultra-rigid 7” M-LOK rail system to provide a pistol that is up for any task.
Our MPP-GI trigger has micro polished contact surfaces, and a fitted disconnector. This combination gives you the 5lb weight of a typical duty trigger, and removes all of the gritty drag while breaking the shot. Our fitted disconnector gives a positive, short reset that is hard to miss!
We finish out our MMP-300’s with a four position SB Tactical SBA3 pistol brace, which is our choice for comfortable braced shooting.
Out of stock
$1,250.00
Out of stock
Forged Lower:
• 7075-T6 Forged Aluminum
• Hard-Coat Anodized Mil 8625 Type 3 Class 2 – Matte Black
• Upper Receiver Tension Screw with nylon tip to remove any slack between lower and upper receiver.
• Detent Set Screw for Rear Take-Down Pin (Captures spring that is normally held in by the End Plate.)
• Bolt Catch Screw (Used in place of the Bolt Catch roll pin)
• Custombilt MPP Trigger: (Micro Polished Performance) GI Trigger
• Custombilt Enhanced Trigger Guard
• 6-Position Mil-Spec Buffer Tube, Carbine Buffer, Stainless Steel Spring
• Magpul MOE Grip
• SB Tactical SBA3 Stabilizing Brace
• Mil-Spec Safety Selector
• Magpul 30 Round PMAG®
Forged Upper:
• 7075-T6 Forged Aluminum
• T-Marked Flat-Top with Picatinny Rails
• Hard-Coat Anodized Mil 8625 Type 3 Class 2 – Matte Black
• Mil-Spec Charging Handle
Handguard:
• Custombilt 7” MLOK handguard,Hard-Coat Anodized Mil 8625 Type 3 Class 2 – Matte Black
Barrel (1:7 twist)
• 8””
• 4150 Chrome Moly Vanadium
• Nitride/QPQ Finish
• Thread: 5/8×24
• A2 Flash Hider
• Front Sight Block
•Pistol- Length Gas System
Custombilt M16 Cut Bolt Carrier Group:
• Properly staked
• Nitride Coated
• Laser Engraved Custombilt Logo
• HPT – High Pressure Tested
• MPI – Magnetic Particle Inspected
• 9310 Bolt
• 8620 Bolt Carrier